New short link!

segunda-feira, 12 de agosto de 2013

Dia de Instructables, e é só coisas práticas!

Quem tiver um Quintalzinho que seja, vai precisar algum dia disto, para não falar em Caves, e todo o resto...
A Bomba de Àgua pifou?
Vai de dar à Bomba à mão!
E atenção, vão ter duas dicas pelo preço de clicarem numa! Também ensina a fazer umas Válvulas porreiríssimas!
É bom!




How To Make A PVC Water / Air / Vacuum Pump!

The King of Random
In this project you'll learn how to make a customizable PVC hand pump that will create vacuum suction, pump water, or compress air.

A pre-requisite to making the pump will be 2 homemade check valves.  You can learn how to make these cheap PVC check valves here!









E corda, já pensaram como fazer Corda da grossa? Eis como a fazer, da maneira mais fácil, e fica porreira!




Rope Making

Mrballeng
Rope making has been around for a very long time. While there are more complicated ways to go about it, this set up is one of the simpler ways. All you really need is a few coat hangers and a couple scraps of wood.
The twine I’m using measures about 1/8”. Six lines of it made a 3/8” rope. Twelve lines made a 1/2” rope.












Continuamos com o melhor Instructable sobre como fazer o vosso Moldador de Vácuo, este usa coisas que se encontram aos pontapés, para fazer algo que tem mil e um usos, com aquecimento, molda placas de Plástico, sem aquecimento, molda placas de Oogoo acabado de fazer, por exemplo:



Vacuum Forming Rig

stechi
I wanted to produce a vacuum forming machine that would allow me to do small parts, just for experimenting.  I wanted to go for a self-contained unit with its own heater and vacuum pump.  I know you can do a lot with an oven and vacuum cleaner, but my challenge was to do something neater than that, a self-contained machine.

I won’t go into how vac forming works, because there are plenty of explanations on the internet.  But the main concerns are to hold the plastic sheet, to heat it, to hold it on an airtight moulding table (platen) and to reduce the air pressure to make the moulding.  In short, the heater softens the plastic sheet that is held in the frame. Then the frame is lowered onto the platen, where the object is.  The vacuum pump underneath then draws out the air under the sheet so that the plastic forms the shape of the object; it cools and the job is done.











E nos vossos Projectos envolvendo Laser, eis como fazer em casa um Módulo como deve de ser, caixa, lente, parafusos para ajustamentos, e tudo:




Homemade laser module

pinomelean

You all know that when making a laser device, the most difficult part it's focusing without buying a module.
So here it is, a complet guide about how to make a focusable laser module with parts you have lying around.
Everybody havs heared about aixiz module, but they're expensive, at least if you know you can do something similar for free.

This module is not recomended for laser diodes over 300mW, because lens can melt and it's not the best heatsink.

the goals I wanted to achieve are:
-Make it easily focusable.
-Make it with household parts.
-make it nice and durable.

I'm very happy with the final results, the module acts as heatsink and it can focus the laser to a single burning point or a beam.










Sem comentários:

Enviar um comentário